I have a glass pipe that was dropped and the bowl cleanly broke off of the stem of the pipe. Is there a safe way to repair this into a working condition?

I used krazy glue on my ash catcher when it broke and haven't had a problem with it, as long as you aren't heating the glue itself it shouldn't matter.

i was going to use krazy glue until i saw all the "toxic fumes, don't enhale" warnings all over it...

i used rubber cement on mine. it had a nice clean break as well. just wait til it's dried all the way and be sure to get the flame in the bowl and there shouldn't be a problem. also it will probably break in that same spot every time from now on (mine did)

my friends ash catcher also broke and glue worked fine, but thats casue that part wont get hot at all. personally i wouldnt risk it since it would be so close to where your heating and it could heat up and release fumes, especially if its a smaller pipe

__________________

....
... ...

smoke weed all day

What about a glue gun?

your asking for shitty fumes if you use a glue gun

aquarium glue has worked good for me in the past , i know they sell it at home depot..

only true love and imagination can fix a bowl my dude.

awgh man.

As hard as it may be, it is time to put the piece to rest and replace it with an new one.....

try a hot glue gun first i used it on my bong it worked ok but my shit was fucked, try man before u ditch the one one, unless u have the oppertunity than hell ya juss buy a new one

I have repaired three glass bubblers with J-B Weld epoxy.
The pipes are stronger than new after repair.

Attached Images

	2pipe repair.jpg (1.58 MB, 5 views)
	4pipe repair.jpg (1.16 MB, 3 views)
	1pipe repair.jpg (1.33 MB, 3 views)
	3pipe repair.jpg (1.24 MB, 5 views)